Commissioning; Communication; Pc Software Installation - Endress+Hauser Memograph M RSG40 Manuel

5.3

Commissioning

Once the operating voltage is applied, the display lights up and the unit is ready for
operation.
• If you are commissioning a unit that is already configured, measuring is immediately
started in accordance with the settings. The values of the display group currently
configured appear on the display.
• When you first commission the unit, configurate the set up in accordance with the descrip-
tion in the Operating Instructions, chapter 6.3.
5.4

Communication; PC software installation

NOTICE
Version V1.25.0.0 (or higher) of the ReadWin 2000 PC software supplied must be installed
to be able to establish communication between the unit and the PC. To be on the safe side,
you should install the current PC software package (CD–ROM supplied).
The Field Data Manager (FDM) analysis software can also be used for centralized data
management with visualization for recorded data.
Essential version of FDM available (free of charge) at:
www.endress.com/ms20
5.4.1 Installing the ReadWin 2000 PC software supplied
The "Arial Unicode MS™" font must be installed on your PC to operate the PC software
supplied. Otherwise certain characters might be displayed incorrectly or not at all. Check this
on your PC under "Control Panel - Fonts". If this font is not installed, please refer to your
®
Microsoft-Office or Microsoft-Windows
NOTICE
You need administrator rights to install the software.
1. Install the supplied PC software on your computer. The program' s Operating
Instructions can be printed out after installation, if required.
2. Once the PC software has been installed successfully, you can launch the software under
"Start -> All programs".
5.4.2 Communication via USB / USB driver installation
Once the PC software supplied has been installed successfully, the unit can be connected to
the PC with a USB cable. The operating system automatically recognizes the new USB unit.
Proceed as follows to then install the USB driver (depends on operating system):
1. The Windows prompt "Should a connection be established with Windows Update to
look for software?" appears. Click "No, not this time" and then "Next".
2. The "What do you want the wizard to do?" window appears. Select "Install the software
automatically (Recommended)" and then click "Next".
You can now start the PC software supplied to establish communication with the unit.
NOTICE
Wait at least 15 seconds before plugging in and out the USB connection from the PC to the
unit!
Commissioning and operation
®
manual.
33