Configuring The Operating Language; Commissioning - Endress+Hauser Memograph M RSG40 Mode D'emploi

Commissioning and operation
32
Operating Operating function
element (Item (Display mode = measured value display)
No.) (Setup mode = operating in the Setup menu)
6 In the Display mode: displays current date/time
In the Setup mode: --
7 In the Display mode: user ID (if the function is enabled)
In the Setup mode: --
8 In the Display mode: alternating display indicating what percentage of the SD card or USB stick has
already been written to.
Status symbols are displayed for the following functions (alternate with the memory information):
simulation mode, data storage active, operating lock, batch active
In the Setup mode: the current "direct access" operating code is displayed
9 In the Display mode: screen for measured value display
Displays the current measured values, and the status in a fault/alarm condition, depending on the
signal display selected. In the case of counters, the type of counter is displayed as a symbol
!
Note!
If a measuring point has limit value status, the corresponding channel identifier is highlighted in red
(quick detection of limit values). When you are operating the unit, measured value acquisition
continues to run without interruption.
10 In the Display mode: alternating status display (e.g. set zoom range) of the analog or digital inputs in
the appropriate color of the channel.
In the Setup mode: different information can be displayed here depending on the display type.
a Slot for SD card
"
Caution!
Do not remove the SD card if the yellow LED (d) is lit! Risk of data loss!
b USB B socket type "function" e.g. for laptop
c USB A socket type "host" e.g. for USB stick
d LED at SD slot
Yellow LED lit when the unit writes to the SD card or reads it.
"
Caution!
Do not remove the SD card if the yellow LED is lit! Risk of data loss!
1) Overview of symbols, see Operating Instructions on CD-ROM.
5.2

Configuring the operating language

The default setting for the operating language is English. A different operating language can be
configured in the main menu.

Press the Navigator -> Language
Fig. 7: Changing the operating language in the main menu
5.3

Commissioning

Once the operating voltage is applied, the display lights up and the unit is ready for operation.
1)
1)
.