Information And Explanation Of Symbols - Unitron Moxi Kiss Guide

Notice 3
This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules
and ICES-003 of Industry Canada. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this device does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the device into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for
help
Australia: Supplier Code Number N15398
New Zealand: Supplier Code Number Z1285
38

Information and explanation of symbols

With the CE symbol, Unitron confirms that this Unitron
product – including accessories – meets the requirements
xxxx
of the Medical Devices Directive 93/42/EEC as well as
the Radio Equipment Directive 2014/53/EU on radio and
telecommunications transmitters. The numbers after the
CE symbol are the numbers of the consulted certified
bodies under the above mentioned directives.
This symbol indicates that it is important for the user to
read and take into account the relevant information in this
user guide.
This symbol indicates that it is important for the user to pay
attention to the relevant warning notices in this user guide.
Important information for handling and product safety.
Australia and New Zealand EMC and
Radiocommunications compliance label.
This symbol indicates that the products described in
these user instructions adhere to the requirements for an
application part of Type B of EN 60601-1. The surface of
the hearing aid is specified as applicated part of Type B.
This symbol shall be accompanied by the name and the
address of the authorised representative in the European
Community.
This symbol shall be accompanied by the name and the
address of the manufacturer (who are placing this device
on the market).
39