Wiring The Module - TIPTEL 2S0 Instructions D'installation

.UK.
·
Insert the expansion module into the designated slot. Ensure
that the module is inserted straight.
·
Replace the top cover and secure it again with the two screws.
During installation, ensure that the upper edge of the expansion
module is located in the corresponding guide of the cover. No
force must be applied when replacing the housing cover and
securing it with the screws.

Wiring the module

·
There are two possibilities for connecting the tiptel 2S0
expansion modules. They can be connected directly via two
modular jacks or via connections to the direct board connector
plug supplied by the user. In the second variant, the following
direct board connector plug assignment must be adhered to:
Pin 1 a2
Pin 4 b2
When using J-Y(St)Y 2x2x0.6 installation cables, the following
colour assignment should be adhered to, for example:
a1 red
b1 black
·
The direct board connector plugs are coded, i.e. inadvertent
swapping with the direct board connector plugs of other expan-
sion modules, such as the tiptel 4ab, is not possible.
Expansion module tiptel 2S0
15
Pin 2 a1
Pin 3 b1
a2 white
b2 yellow
.UK.