Connection To The Network; Connection Test - TIPTEL 410 Guide D'installation

Note: In case you wish to connect two ISDN telephones you need a suitable
adapter or you must install an S
telephone system at an ISDN connection it is possible to switch the S
connector which is set to external as factory default to internal. Then
you can also use it for operating ISDN or system telephones. Instruc-
tions can be found in the Installation Manual on the attached CD.

Connection to the network

As shown below you can connect the LAN connector of your telephone system to the
LAN port of your internet router or your Ethernet switch by using the LAN cable that
came along with your telephone system. In case you do not have a router you can
connect it directly to the LAN port of your PC.
Now you may plug in the AC adaptor to a mains wall outlet.

Connection test

You may test the correct connection by picking up the handset of a telephone. Now
dial the internal extensions 50 to 53 which should cause the connected analogue tel-
ephones to ring. When dialling extensions 20 the ISDN telephone should ring.
To place a call to an external subscriber you must use 0 (zero) as prefix before the
real telephone number. External access by using 0 as prefix may be deactivated in
the configuration of the telephone system.
Quick Installation Guide
bus. In case you do not operate the
0
17
0