Safety Notes - TIPTEL 410 Guide D'installation

Safety notes

The device may not be installed or operated in the following environments:
in the open
o
in damp or wet rooms (bathroom, shower, swimming pool ...)
o
at locations with direct sunlight
o
in explosive areas
o
with ambient temperatures below 0 °C or above 40 °C
o
with strong concussions or vibrations
o
in dusty environment
o
The device has been designed for wall mounting, the device must not be covered and

must have a distance of at least 10 cm to any other objects (this of course does not
apply to the module)
During a thunderstorm you should neither use the phone nor connect or disconnect

any cables (Danger of an electric shock when a lightning hits the telephone network).
Unauthorized removal of the telephone system's cover or inappropriate repairs may

result in hazard for the user.
When disposing of the device all applicable national laws and regulations must be

obeyed.

In case of a power outage emergency calls cannot be made without a UPS.
this rule please see the User's Manual of your device. Dial locks may block emergen-
cy calls.
Install all connection cables with care so that no tripping hazards result from the in-

stallation. Connection cables may not be bent excessively, pulled, or stressed me-
chanically. Connection cables may only be installed inside of buildings.
ISDN connections, data and audio ports are SELV circuits and may only be connect-

ed to circuits which are also SELV themselves.
With any malfunction the power cord must be removed from the wall outlet and all tel-

ecommunication cables must be disconnected.
FXO lines (external analogue lines) may not be connected to the public telephone

network in the following countries: Finland, Norway, and Sweden.
External analogue lines may only be connected to TNV circuits with a maximum

source voltage of 60 V.
Installations must be carried out by persons having the appropriate technical training

and experience necessary to be aware of the hazards to which they are exposed in
performing a task and of measures to minimise the danger to themselves or other
persons.
Applicable regulations in accordance with IEC60950 and IEC60364 have to be ob-

served.
Equipment with connection to AC supply circuits may lead to an accumulation of con-

tact currents at the telephone system. The service personnel must make sure that the
touch current (leakage current) at no time will exceed 3.5 mA.
Devices with protective earth plugs (safety plugs) may only be connected to wall out-

lets with protective earth contact.
Before opening the cabinet the system must be disconnected from mains (remove

power cord) and from any telecommunication cables
Power supplies may only be used if approved by the manufacturer

Quick Installation Guide
13
For exceptions to