TIPTEL 410 Guide D'installation page 14

Quick Installation Guide
Introduction
This quick installation guide handles the connection of the telephone system to ISDN
and analogue exchange office lines. Here, only operation at ISDN and analogue ex-
change office will be dealt with. Connection of telephones is only referred to as direct
plug-in to the connectors of the telephone system.
On the enclosed CD you will find the User's and the Installation Manual as pdf docu-
ments to be viewed with the Acrobat Reader.
The Installation Manual gives you detailed information on the configuration of the tel-
ephone system while the User's Manual teaches you about the operation of tele-
phones connected to the telephone system.
In these documents you also read how to switch the S buses from external to inter-
0
nal, how to configure external S buses as point-to-point connection, and how to
0
connect more than one ISDN or IP telephones.
In case you do not have any ISDN or analogue exchange office connection available
and you would like to only use VoIP telephony you will find all necessary information
on this configuration in the Installation Manual on the CD.
Also on the CD you will find documentation of the modules tiptel 2FX0, tiptel VCM
and tiptel VoIP CP 8/16, which is optional with tiptel.com models and already in-
stalled with tiptel compact models.
Connecting the telephone system to an ISDN exchange
office
Connect the NTBA of your ISDN connection by using the ISDN cable (thin, black)
which came along with your telephone system with first connector from the left at the
bottom side of your telephone system as shown below. In case you do not have any
ISDN connection just leave this connector empty.
14