TIPTEL 410 Guide D'installation page 15

Note: Factory settings of the telephony system are configured for an ISDN
point-to-multipoint connection. In case you wish to operate the tele-
phone system at a point-to-point connection please dial

Connecting the telephone system to an analogue
exchange office
Connect the first two connectors from the right with the wall outlets of your analogue
exchange office by using the cables that came along with your telephone system as
shown below.
In case you only have one analogue exchange office line, please use the first con-
nector from the left. In case there is no analogue exchange office line please leave
both connectors empty.
Quick Installation Guide
at any phone.
15