TIPTEL 410 Guide D'installation page 18

Configuration access
The telephone system can be configured by using a web browser. In the address bar
of the web browser you will have to enter the IP address of your telephone system.
After entering user name and password (factory default is admin : admin) the config-
uration assistant will open in your browser which will guide you through the basic
configuration of your telephone system. After completion of the guided installation
the complete configuration interface will be available to you in your web browser. In-
structions on how to use the assistant as well as on the complete configuration you
will find in the Installation Manual on the attached CD.
In case you connected the telephone system to an internet router with an active
DHCP server the telephone system will obtain an IP address from the router's ad-
dress range. In case there is no active DHCP server or it was connected directly to a
PC the telephone system itself will act as DHCP server and will assign IP addresses
via its integrated DHCP server. The IP address of the telephone system in this case is
192.168.34.100.
Note: To query the telephone system's IP address please dial at a connected
telephone
then call that telephone and shows you its IP address on the tele-
phone's display.
Detailed instructions on connection to a router or a computer together with eventually
necessary settings in your operating system and access to the telephone system can
be found in the Installation Manual on the attached CD.
Further operation
For further operation of telephone functions please read the User's Manual on the CD
that came along with your telephone system.
Further configuration
For further configuration of the telephone system please read the Installation on the
CD that came along with your telephone system.
Quick Installation Guide
, and the hang up again. The telephone system will

18