Festo SPC200 Mode D'emploi page 13

1 Notes on useEnglish
The field bus module type SPC200-COM-CAN has been
designed for coupling the SPC200 to the DeviceNet. With
this field bus module the SPC200 can be operated as a
slave on the relevant field bus. For user-friendly commis-
sioning of an SPC200 with the integrated field bus module,
you will require the WinPISA software package as from
version 4.1. Detailed information on the field bus module
can be found in the manual P.BE-SPC200-COM-CAN...-... .
Caution
Pay strict attention to the following instructions in the
manual:
– The safety guidelines
– The designated use of the individual components
and modules.
Warning
Actuators can be unintentionally activated and the
SPC200 can be damaged if components are added or
removed when the power supply is switched on. Before
undertaking installation and/or maintenance work,
switch off the following sources of power in the se-
quence specified:
1. The compressed air supply
2. The load voltage and operating voltage for the
SPC200.
Festo SPC200-COM-CAN 0012NH English 13