Rules Of Use; Remissage And Transport - Active OLIVATOR E 20 Manuel D'instructions

The machine is equipped with an electric motor to 12Volt
with 5-speed.
When electrical connection using the cable supplied, the
scuotitore is stopped.
The light bulbs (red and green) placed next to the switch,
turn both for a short time. If this does not happen, the
battery is completely discharged or probably the cables
are connected to the wrong polarity.
This does not imply any damage to the electronic circuit,
which is protected.
Make the setup.
REMEMBER:
PINZA RED + POSITIVE cable brown
PINZA BLACK - NEGATIVE cable blue
If the battery is charged, remains only the light turned
green.
To press the start button-1 accelerated at the time marked
with the letter "H".
To increase speed press and release sino still obtaining
the desired speed.
To reduce or turn off the press to "L" opposite.
WARNING
Keeping always pressed the button-speed, speed does
not vary.
REMISSAGE
Always disconnect the battery cables.
Scuotitotore the perfectly clean and keep it in a dry place
and away from dust and weather.
Place the scuotitore with the end of the 2 balls raised to
avoid their permanent deformation

8. RULES OF USE

LEVEL INDICATOR OF CHARGE THE BATTERY
If the battery is charging between 60 and 100%, the
green light is on and fix.
If the battery is charging between 40 and 60%, the light
blinks green.
If both lights are lit the battery is low (20-40%)
If the red light is on the battery is completely
discharged.
For maximum yield is good that the green light is fixed at
the time of work.
Regarding the duration of charging a battery, note that the
scuotitore has un'assorbimento average of 8-10 A.
In any case, the battery life depends primarily on the
ability and the degree of the same charge.
E 'can connect it directly to a charged battery or a
generator!
We recommend the use with battery.
SUPER HEATERS
The electronic board that controls the speed, has a
thermal protection against overheating.
In this case the red light flashes 4 times and the motor
stops themselves.
Where once raffreddatosi no longer the alert, press the
button-accelerate to resume work.

9. REMISSAGE AND TRANSPORT

TRANSPORT OR DISMANTLING
In the case of disassembly for transport or maintenance
proceed as follows:
1. Loosen the clamping ring placed on gr.motore.
2. Pull off the transmission pipe maintaining raised the
pivot solutions.
(To remove the tube from support to "Y" must loosen up
the 4 screws on the end of the medium itself).
17
GB
ENGLISH