Preliminary Operations; Periodic Maintenance - Active OLIVATOR E 20 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
GB
ENGLISH
ELECTRICAL CONNECTION BETWEEN OLIVATOR E20
AND BATTERY CHARGER (PHOTOS ....)
- Connect the connector (10) to the socket (1)
- Push the side button (2) and check light signals on the
screen (3), in order to test the level of the battery
- To charge the battery:
Disconnect the connector (10)
WARNING
Before using the scuotitore read carefully the safety rules.
Always carefully inspect the car before use. Verify that
there are no screws loose, damaged cables and
damaged. Make sure the transmission pipe (5) has been
installed and that it is tight. Check periodically the
condition of rotating parts. Always check that the ball roto-
vibrant present no breakage or damage and which rotate
freely. Otherwise we recommend their replacement or
replacement of their bearings before the final break, not to
cause damage to the transmission.
AVOID USE OR MISUSE OF SCUOTITORE
For proper operation, rotating parts are supported against
the branches, resulting in a gradual and soft vibration.
We recommend you start to moderate speed, increasing
gradually, if necessary.
Check, during use, that there are foreign bodies that could
tangle on rotating parts or be projected dangerously
remote.
Always keep both hands with the scuotitore to avoid
strattoni or attorcigliamenti side
MANTA CLEAN AND NOT ALWAY OBSTRUCTED
THE EYELETS COOLING ON BODY ENGINE.
Clean the ball roto-vibrating from any twigs, leaves or other
things that might impede their free rotation.
Do not lubricate the outside of the areas moving to avoid
unnecessary and harmful imbrattamenti dust. (The internal
movement is already sealed and lubricated for mounting
Connect the connector (4) to the socket (1)
Connect the plug (7) to the socket (9)
Connect the plug (8) to the socket
Now the led (5) will be in red colour. When it becomes
green, the battery will be charged. Now it's possible to
disconnect all plugs and to connect the connector (10) to
the socket (1).

6. PRELIMINARY OPERATIONS

The scuotitore is not water, it is equipped with an electric
motor and an electronic circuit and then not ever immerse
it in or liquidi.Evitarne water use during storms and days
of pioggia.La form of the machine can attract lightning that
could cause death or serious injury.
Make sure the work area there are electrical cables and / or
high voltage
Contact with them could cause death or serious injury.
STOP ENGINE
Press the pusante accelerated towards the "L" buttons to
obtain the arrest of the unit. Detach hours cables from the
battery.
E 'advisable to proceed in this way before unplugging the
cables, to prevent sparks or sudden changes in load.

7. PERIODIC MAINTENANCE

The eyelets cooling Gr.motore must be free and clean to
avoid overheating the engine or tab elettronica.Si advised
to clean with compressed air to the engine stopped.
16
DO NOT USE DURING THE TIME
WARNING
All servicing not given in this manual should be
performed by a factory authorized.

Publicité

Table des Matières
loading

Table des Matières