Packing Up; Operations And Maintenance For Battery - Active TIGERCUT 40 Manuel D'utilisation Et D'entretien

Packing up

1. Press the trigger and hold for a few seconds and then release, the blade will close
and will not open .
2. Switch o the battery. disconnect the power cord from battery.
3. Tidy up, clean up and pack the pruner into the tool box.

Operations and maintenance for battery

1.
Do not charge the battery in environments with temperatures below 0 ° C or above
of 45 ° C.
2. Make sure that the battery switch is in the OFF position before connecting
the charger on power. Then put the switch in the ON position.
3. Use only the charger supplied with the scissors. The use of chargers
that do not correspond to the speci cations on the plate may cause re.
4. Objects such as keys, coins, rings, screws and any other conductive object must
be stored away from the battery when it is not in use.
5. Do not disassemble the battery.
6. Do not cause short circuit in the battery.
7.
Do not use the battery near heat sources.
8.
Do not burn or immerse the battery in liquids.
9.
Do not charge the battery near an open ame or in direct sunlight.
10.
Do not insert nails, step on or force the battery. Don't shock her.
11.
Do not use the battery if damaged or deformed.
12. Do not weld on the battery.
13. Do not reverse the battery charging polarity.
14. Do not connect the battery to external chargers or cigarette lighters in cars.
15. Do not connect the battery to machines other than this electric scissor.
16. Avoid direct contact with the lithium cells of the battery.
17. Do not insert the battery in the microwave oven.
18. Do not use batteries that show leaks.
19. Keep the battery out of the reach of children.
20. Do not use or store the battery in direct contact with sunlight (or in a vehicle
under the sun). This causes overheating and shortens the battery life.
21.
Do not use the battery in electrostatic environments.
22.
Do not use the battery if it is corroded, smelly or with an unusual appearance.
23.
If skin or clothes come into direct contact with battery uids, wash and
clean immediately with water.
24. Recharge the battery every 3 months when not using the electronic scissors.
25. When the battery is running out of charge, the reduction of the cutting diameter
it is to be considered normal.
21