Malfunctions - SATA BVD Mode D'emploi

Operating Instructions
Warning!
Risk of injuries from components coming loose
Components may come loose unexpectedly when working on the pres-
surized cup spray gun while this is still connected to the compressed air
circuit.
→ Always disconnect the pressurized cup spray gun before any kind of
work and vent it completely.
Attention!
Damage from wrong cleaning agents
The use of aggressive cleaning agents can cause damage.
→ Do not use aggressive cleaning agents.
→ Use neutral cleaning agents with a pH of 6 – 8.
→ Do not use acids, caustic solutions, bases, paint strippers, unsuitable
regenerates or other aggressive cleaning agents.
Attention!
Physical damage from incorrect cleaning
The pressurized cup or spray gun can be damaged if immersed in sol-
vent or cleaning agent or if cleaned in an ultrasonic cleaning machine.
→ Do not place the pressurized cup with spray gun in solvent or clean-
ing agent.
→ Do not clean the pressurized cup with spray gun in an ultrasonic
cleaning machine.
→ Only use cleaning equipment recommended by SATA.

12. Malfunctions

The following table describes malfunctions, their causes and correspond-
ing remedies.
If it is not possible to remedy the malfunctions with the described correc-
tive action, send the pressurized cup spray gun to the SATA customer
SATA BVD
EN
35