General Instructions; Getting To Know Your Safety Seat - JANE IKONIC Mode D'emploi

C. GENERAL INSTRUCTIONS
In order to protect your baby adequately and to ensure
their comfort and stability in the car, the following ins-
tructions must be strictly followed:
This seat is only suitable for cars fitted with the ISOFIX
anchoring system, approved under Regulation ECE-14 or
other equivalent standards.
Your IKONIC safety seat can be installed on the front
seat, if it is not fitted with an airbag, or back seat of your
vehicle. However, we advise you to install it on the back
seat. If it is installed on the front seat of the vehicle, make
sure it IS NOT fitted with an airbag, or that the airbag is
disconnected. You should also check the Traffic Law of
the country where you are driving.
Not all safety systems are exactly the same, therefore
we advise you to check your IKONIC in the car in which it
is going to be fitted.
It is very important not to use second-hand products,
as JANÉ can only guarantee complete safety with items
used by their first buyer.
JANÉ recommends that you replace your IKONIC safety
seat with a new one if it has been subjected to violent
stress in an accident.
Check that all the seat straps are in the correct position
IM 2046_02_IKONIC alta.indd 33
and duly adjusted to your IKONIC. Make sure that none
of the straps are twisted. The child must understand that
he must not play with the straps or fasteners under any
circumstances.
Do not install the safety seat on sideways seats in the
vehicle or rear facing seats, this is very dangerous.
D. GETTING TO KNOW YOUR
SAFETY SEAT
Your IKONIC safety seat has been designed taking into
account the latest advances in terms of safety and it has
been tested under the toughest conditions. It has the
following features:
Installing in the vehicle:
Ready for easy installation with the ISOFIX system (See
section INSTALLING THE SEAT IN THE CAR of these ins-
tructions).
Comfort and safety for the baby:
Integrated 5-point harness, with a greater fastening
area, so distributing the loads on the baby better in the
event of an accident.
Ventilation in the shell making it more breathable.
Impact absorbing material over the entire surface in
contact with the baby.
33
EN
10/7/18 10:20