DeWalt DCG440 Guide D'utilisation page 19

hubbed sanding Flap Discs
Type 27 guard
(Deep) N527182
Hubbed sanding
flap disc
non‑hubbed sanding Flap Discs
Type 27 guard
(Deep) N527182
Non-Hubbed sanding
flap disc
Locking flange N452728
hubbed Wire Cup Wheels
Type 27 guard
(Deep) N527182
Hubbed wire
cup wheel
hubbed Wire Wheels
Type 27 guard
(Deep) N527182
Hubbed wire wheel
Type 27 spacer
Type 27 spacer N830903 is used to hold a
wider diameter on wheels and to gap the T27
depressed center wheel further down in the
Type 27 Guard (Deep) N527182.
Type 27 Depressed Center grinding Wheels
Type 27 guard
(Deep) N527182
Type 27 spacer
N830903**/***
Type 27 depressed
center wheel
Nut N665613**/***
Type 27 guard (shallow)
Type 27 Guard (Shallow) N775399** is used
to reduce angle of operation and minimize gap
between the guard.
Type 27 Depressed Center grinding Wheels
Type 27 guard
(Shallow) N775399**
Type 27 depressed
center wheel
Locking flange N452728
Type 1/41 Cutting Wheels
Type 1/41 guard
N532558**
Type 1/41 abrasive
cutting wheel
Locking flange N452728
Diamond Cutting Wheels
Type 1/41 guard
N532558**
Diamond cutting
wheel
Locking flange N452728
sanding Discs
Rubber backing pad
DAJHXKMDO1**
DAJHXKHDO1**
Sanding disc
Sanding clamp nut
(Included with
rubber backing pad
DAJHXKMDO1** or
DAJHXKHDO1**)
hubbed Wheel Wrench
Hubbed wheel wrench
N541784**

Type 1/41 guards are intended for use with Type
1/41 cutting wheels and Type 27 wheels marked for
cutting only. Grinding with wheels other than Type
27 and Type 29 require different accessory guards.
Always use the smallest proper guard possible that
does not contact the accessory.
** nOTE: Available at extra cost from your local dealer or
authorized service center.
*** nOTE: These can be used with only the Type 27 guard,
N527182 guard.
† nOTE: Type 28 depressed center wheels only.
English
17