Commissioning; Attaching The Extraction Hose - Abicor Binzel xFUME ADVANCED 115V-CSA Mode D'emploi

xFUME™ ADVANCED 115V – CSA

6.1 Attaching the extraction hose

A maximum of two fume extraction torches may be attached to the device. If only one fume extraction torch
is connected, the cap for the second connector should be closed to ensure optimal extraction.

6 Commissioning

Remove the cap from the intake fittings.
1
Screw the connectors on both ends of the
2
extraction hose.
Connect one end of the extraction hose with
3
connector to the welding torch cable assembly.
Connect the other end of the extraction hose to the
4
device's intake fittings.
A maximum of two fume extraction torches may be
attached to the device.
EN - 13