Cautions For Use - Panasonic PV-GS120 Mode D'emploi

ª Using the DV Cable for Recording
(Digital Dubbing)
≥Regardless of the setting, digital dubbing is
carried out automatically in the same audio
recording mode as that of the playback
Cassette.
≥The images on the recording monitor may be
disturbed, but it does not affect the recorded
images.
≥Even if Playback Digital Effects, Playback
Zoom, or Playback Title In have been used,
these effects are not output from the DV
Terminal.
≥Even if you use a device equipped with DV
Terminals, you may not be able to perform
Digital Dubbing in some cases.
≥Date or other information to be displayed cannot
be displayed if the software of the connected
equipment does not support the display
function.
≥You cannot record on a tape when MPEG4
recording from external input signals is in
progress. (PV-GS200 only)
≥You cannot record on a card when recording on
a tape from external input signals is in progress.

Cautions for Use

ª After Use
1
Take out the Cassette. (
2
Set the [OFF/ON] Switch to [OFF].
3
Take out the Card. (
4
Detach the power supply and retract the
Viewfinder or the LCD Monitor. (
5
To protect the Lens, attach the supplied
Lens Cap.
ª Cautions for Use
When you use your Camcorder on a rainy or
snowy day or on a beach, make sure that no
water enters the Camcorder.
≥Water may cause the Camcorder or Cassette to
malfunction. (Irreparable failure may occur.)
≥If sea water splashes onto the Camcorder, wet
a soft cloth with tap water, wring it well, and use
it to wipe the camera body carefully. Then, wipe
it again thoroughly with a soft dry cloth.
Keep the Camcorder away from magnetized
equipment (such as a microwave oven, TV,
video game equipment, etc.).
≥If you use the Camcorder on or near a TV,
images or sounds may be disturbed due to
electromagnetic wave radiation.
≥Do not use near a cell phone because doing so
may cause noise to adversely affect the picture
and sound.
)
-18-
)
-19-
, )
-16- -20-
Others
≥Recordings on the tape may be damaged, or
images may be distorted, by strong magnetic
fields created by speakers or large motors.
≥Electromagnetic wave radiation generated by a
microprocessor may adversely affect the
Camcorder, causing the disturbance of images
and sounds.
≥If the Camcorder is affected by magnetically
charged equipment and does not function
properly, turn off the Camcorder power and
detach the Battery or AC Adaptor and then
connect the Battery or AC Adaptor again.
Thereafter, turn on the Camcorder power.
Do not use your Camcorder near radio
transmitters or high-voltage cables.
≥If you record pictures near radio transmitters or
high-voltage cables, recorded images or sounds
may be adversely affected.
Do not use this Camcorder for surveillance
purposes or other business use.
≥If you use the Camcorder for a long period of
time, the internal temperature increases and,
consequently, this may cause malfunction.
≥This Camcorder is not intended for business
use.
When you use your Camcorder on a beach or
similar place, do not let sand or fine dust get
into the Camcorder.
≥Sand or dust may damage the Camcorder or
Cassette. (Care should be taken when inserting
and removing the Cassette.)
Do not spray insecticides or volatile
chemicals onto the Camcorder.
≥If the Camcorder is sprayed with such
chemicals, the camera body may be deformed
and the surface finish may peel off.
≥Do not keep rubber or plastic products in
contact with the Camcorder for a long period of
time.
Do not use benzine, thinner or alcohol for
cleaning the Camcorder.
≥The Camcorder body may be deformed and the
surface finish may peel off.
≥Before cleaning, detach the Battery or pull out
the AC Cable from the AC Jack.
≥Wipe the Camcorder with a soft dry cloth. To
remove stubborn stains, wipe with a cloth that is
soaked in a detergent diluted with water and
afterwards finish wiping with a dry cloth.
≥For storing or transporting the Camcorder,
place it in a bag or case lined with soft pads so
as to prevent the coating on the camera body
from being worn.
-78-