Playback Mode; Playing Back A Tape; Finding A Scene You Want To Play Back - Panasonic PV-GS120 Mode D'emploi

Playback Mode

Playing Back a Tape

The recorded scene can be played back
immediately after the recording.
1
Set the [OFF/ON] Switch
≥The [POWER] Lamp
(41)
POWER
ON
(43)
2
Set the Mode Dial (39)
Mode.
(39)
3
Press the [6] Button
tape.
STILL
(19)
s ENTER i
FADE
≥Rewind the tape to the point where you want
to start playback.
≥When the tape reaches the beginning,
rewinding stops automatically.
4
Press the [1] Button
≥The [!] Indication appears.
STILL
(17)
ENTER
s i
FADE
≥If a cassette recorded with a copyright
protection signal is played back, the picture is
distorted by mosaic-like patterns.
To Stop Playback
Press the [∫] Button (18)
STILL
(18)
ENTER
s i
FADE
Playback Mode
(43)
to [ON].
(41)
lights up.
to Tape Playback
(19) to rewind the
(17) to start playback.
.
ª Adjusting the Sound Volume
To adjust the volume, push the [`VOL/JOG_]
(46)
Lever to display the [VOLUME] Indication.
Push the [`VOL/JOG_] Lever towards [T] to
increase the volume or push the [`VOL/JOG_]
Lever towards [W] to decrease the volume. The
[VOLUME] Indication goes off after the
adjustment is finished.
VOL/JOG
W T
(46)
To adjust the volume with the Remote Controller,
press the [T] or [W] Button to display the
[VOLUME] Indication. Press the [T] Button to
increase the volume or press the [W] Button to
decrease the volume. The [VOLUME] Indication
goes off after the adjustment is finished.
≥The sound volume cannot be adjusted using the
Remote Controller in Playback Zoom Mode.
( )
-44-
≥For other notes concerning this item, see
Finding a Scene You Want to Play
Back
ª Cue/Review Playback
STILL
ENTER
s
FADE
(19)
If the [5] Button (16)
pressed during Playback, it turns to Cue Playback
A or Review Playback B.
A
≥If the Button is held continuously, it turns to Cue
Playback or Review Playback until you release
it.
-42-
-75-
i
(16)
or [6] Button (19) is
B
.