Troubleshooting - Dometic PERFECTWALL PW 1000 Instructions De Montage

Masquer les pouces Voir aussi pour PERFECTWALL PW 1000:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 278
PW1000, PW1500, PW1750
8.5
Patching small holes in the fabric
You can patch any small holes in the fabric or parts where the coating has come off:
➤ Use a cotton cloth to rub around the damaged area with a small amount of liquid
vinyl plaster (ref. no. 9103104018, available from your service partner).
✓ The liquid vinyl plaster dissolves the coating. The coating seals the hole when it
dries.
➤ Wait until the area is dry before you retract the awning again.
9

Troubleshooting

I
NOTE
If you are not able to rectify a fault with the help of the following table,
please contact the relevant service partner in your country (see the back
of the manual for the address).
Fault
PW1500/PW1750
only:
The motor is not
responding to the
remote control.
EN
Possible cause
The remote control
battery is flat.
The remote control is no
longer or not properly
set to the motor.
No power supply
available
The motor is defective.
Suggested remedy
Briefly press one of the buttons
. If the remote control LED does not
light up, the battery is flat.
Replace the battery, see chapter
"Replacing the batteries of the remote
control and the wall switch (only
PW1500/PW1750, optional)" on
page 24.
Reprogram the remote control, see the
installation manual.
Check the electric connections.
Retract the awning manually and
contact the service partner in the
respective country.
Troubleshooting
or
27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Perfectwall pw 1500Perfectwall pw 1750

Table des Matières