Troubleshooting; Warranty - Dometic ROLLER Serie Instructions De Montage Et De Service

Rollerblind PrecisionRise
➤ Fully deploy the blind to clean the fabric.
➤ Fully stow the blind to clean around guide wires.
Spot cleaning
➤ Spot-clean with a soft white cloth, moistened with warm water. Add a mild deter-
gent if needed (non-abrasive and with no additives).
➤ Blot gently to avoid creasing or damaging the fabric. Always leave the blind
deployed to dry thoroughly.
Cleaning windows
➤ Always ensure your blinds are fully stowed before cleaning windows. This will
prevent spoiling the blind fabric by splatter or sprays of water or detergent.
9

Troubleshooting

Fault
Guide wire tension too low
Guide wire too short
Guide wire broken
Guide wire blind not running
smoothly
Fabric rolls off sides of ends of
roller
10

Warranty

The statutory warranty period applies. If the product is defective, please contact your
retailer or the manufacturer's branch in your country (see dometic.com/dealer).
For repair and warranty processing, please include the following documents when
you send in the product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
EN
Solution
➤ See chapter "Fitting the guide wire versions" on
page 7.
➤ Order replacement guide wire, see spares leaflet at
dometic.com.
➤ Order replacement guide wire, see spares leaflet at
dometic.com.
➤ Check restraint positions and recess dimensions.
➤ Check if the guide wires or side tracks are perpen-
dicular to the roller and that the roller is horizontal.
Troubleshooting
9