Technical Description; Installation - Dometic ROLLER Serie Instructions De Montage Et De Service

Technical description

This manual provides information that is necessary for proper installation and/or
operation of the product. Poor installation and/or improper operating or mainte-
nance will result in unsatisfactory performance and a possible failure.
The manufacturer accepts no liability for any injury or damage to the product
resulting from:
• Incorrect assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts
provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and product
specifications.
5 Technical description
Blinds are available in two mounting types in different sizes:
• MP: Mounting profile
• CA: Cassette (available in sizes C1, C2, C3)
There are two different types of restraints:
• FH: Free hanging
• GW: Guide wire (available as Dome (A), Flush Mount (B), Low Profile (C) and
Extended (D), see GW versions in fig. 1)
The number on the product label indicating the blind type is located:
• For MP versions on the back of the mounting profile
• For CA versions on the back of the cassette
6

Installation

6.1 Fitting the blind
A
NOTICE! Damage hazard
Consider using two people to install the product if the blind is large or
the installation location is difficult to reach alone.
6
Rollerblind PrecisionRise
EN