Dometic PERFECTWALL PW 1000 Instructions De Montage page 250

Operating the awning
➤ Double-check that the awning is fully retracted before starting your journey.
The lead rail should be right up against the housing.
➤ Remove the hand crank from the holder on the awning.
A
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
Retracting the awning using a 12 V motor (only PW1500/PW1750,
optional)
➤ Press the button
extended by about 1.5 metres. Position the struts vertically and back under the
lead rail every 30 cm so that the awning stays secured at all times.
➤ Fold the lever of the right strut down to loosen the struts.
➤ Slide the struts together completely.
➤ Fold the right strut up.
➤ Turn the right strut into the lead rail.
➤ Slide the bottom part of the right strut into the latch of the lead rail.
➤ Retract the other strut in the same way.
➤ Press the button
completely retracted.
➤ Double-check that the awning is fully retracted before starting your journey. The
lead rail should be right up against the housing.
A
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
22
of the switch or the remote control until the awning is only
of the switch or the remote control until the awning has been
PW1000, PW1500, PW1750
EN