Dometic PERFECTWALL PW 1000 Instructions De Montage page 11

PerfectWall
➤ Clean the outer sides of the lower section and the installation surface in the
vehicle.
I
NOTE
Make sure that no glue gets on to the movable upper section of the
mounting bracket.
➤ To glue and seal, apply an elastic adhesive, such as Sikaflex
the back of the mounting bracket.
➤ Fasten the mounting bracket with drill screws (fig. j, page 2).
or
➤ Rivet the mounting bracket (fig. j, page 2).
Installing the crank bracket
➤ Mount the mounting bracket for the crank at a suitable location inside the vehicle
(fig. k, page 2).
Mounting the tension rafter
Awnings with a width of 4 m to 5.5 m must be secured with a tension rafter.
➤ Attach the pre-drilled end of the tension rafter to the latch for the tension rafter
using the hexagon head bolt and the hexagon nut (fig. l, page 2).
➤ Insert the lower section of the tension rafter into the upper section (fig. l,
page 2).
EN
Installing the awning
®
-221 for example, to
11