Adjusting The Battery Tray; Install The Vehicle Battery - Horizon Hobby axial GRAVE DIGGER SMT10 Mode D'emploi

ADJUSTING THE BATTERY TRAY

1.Remove clip to open battery access door
2.Slide battery into try to check clamp height
3.Remove x4 M3x8mm AXA434 screws

INSTALL THE VEHICLE BATTERY

1
Remove the body
2
Turn on transmitter
4.Adjust battery clamp to fit snug against battery.
5.Reinstall x4 M3x8mm screws
6.Close battery access door and insert clip
3
lnstall and connect the battery
4
7
Reattach the body to vehicle
Power to the vehicle is controlled by the on/off
switch located on the left side of the ESC
Always unplug the battery when not in use,do not
leave vehicle stored plugged in.
EN