Closing The Door - AEG AGS88800F1 Notice D'utilisation

Problem
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
Possible cause
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
The FROSTMATIC or COOL-
MATIC function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FROSTMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
ENGLISH
Solution
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.
Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".
Keep the button pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
29