Replacing The Lamp; Closing The Door; Technical Data; Installation - AEG SANTO K 9 12 03-6i Notice D'utilisation

26

Technical data

Problem
The temperature in the
refrigerator is too high.

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
3. Replace the lamp with one of the same
power (the maximum power is shown on
the lamp cover).
4. Install the lamp cover by sliding it into its
original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light
comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Force Center.
Technical data
Dimension of the recess
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

Installation

Positioning

WARNING!
If you are discarding an old appliance that has a lock or catch on the door, you must ensure
that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
All manuals and user guides at all-guides.com
Possible cause
There is no cold air circulation in
the appliance.
Height
Width
Depth
Solution
Make sure that there is cold air
circulation in the appliance.
1225 mm
560 mm
550 mm