Replacing The Lamp; Closing The Door - AEG SANTO K 9 12 40-7i Notice D'utilisation

28 What to do if...
Problem
Water flows into the re-
frigerator.
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
3. Replace the lamp with one of the same
power (the maximum power is shown on
the lamp cover).
4. Install the lamp cover by sliding it into its
original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light
comes on.

Closing the door

1. Clean the door gaskets.
All manuals and user guides at all-guides.com
Possible cause
The water outlet is clogged.
Products prevent that water
flows into the water collector.
COOLMATIC or FROSTMATIC
functions switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
Solution
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Switch off COOLMATIC or FROST-
MATIC manually, or wait to set the
temperature until the function
has reset automatically. Refer to
"COOLMATIC or FROSTMATIC
function"..
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.