User Settings - Dri-Eaz DriTec 4000i Manuel Du Propriétaire

USER SETTINGS

Only menu items followed by a greater-than symbol (>) may be adjusted. In the menu items with reading data (INLET OUTLET, REACT
& HEATER1 CURRENT), If no keys are selected for 5 minutes the display will return to normal display mode. In all the other menu
items, the display with return to the normal display mode after 20 seconds. Items without the symbol (>) are for information only and
cannot be changed or reset.
MAIN MENU: Press
DISPLAY MENU
to proceed to the
next menu item. ↓
JOB HOURS
RESET? >
INLET OUTLET
For information only.
000° 00% 000°00%
REACT
For information only.
000° 00%
HEATER1 CURRENT
For information only.
00 A
HUMIDISTAT MODE
OFF >
HUMIDISTAT
SETPOINT 00% >
RH MIN SETPOINT
00% >
LANGUAGE
ENGLISH >
TEMP UNITS
°F >
LIFE HOURS
For information only.
00000 HRS
(Returns to
top menu item.)
The following section available only on wireless-equipped units.
SENSOR ID
000000000 >
(Returns to
top menu item.)
49-109H F533
SUBMENUS: Press MENU SELECTION to change the setting.
JOB HOURS
Press
XX.X
HUMIDISTAT MODE
Press
ON >
to cycle through 5 – 60% at 5% increments.
Press
to cycle through 0 – 30% at 5% increments.
Press
IDIOMA
ESPANOL >
TEMP UNITS
Press
°C>
SENSOR TYPE SENSOR REVISION
00000 >
to reset to 0.
to turn ON or OFF.
SPRACHE
DEUTSCH > FRANCAIS >
to change to °F or °C.
SENSOR CONF REV
00000 >
4
→
LANGUE
Press to change lan-
guage options.
00000 >
Dri-Eaz Products, Inc.