JVC RX-DP20VBK Manuel D'instructions page 12

Front speakers 1
Right / Left
FRONT 1 SPEAKERS
+
CAUTION :
SPEAKER
IMPEDANCE
FRONT 1 AND 2
/ ZONE 2:
8 16
–
FRONT 1 OR 2:
4 16
RIGHT
Zone 1 speaker layout
Ideal speaker layout varies depending on the conditions of your
listening room. The diagram below is a recommended typical
example.
Left front speaker(s)
(L)
Center speaker
(C)
Left surround
speaker (LS)
Surround back speakers (LSB/RSB)
9
Center speaker
FRONT 2 /
SPEAKER
ZONE 2 SPEAKERS
LEFT LEFT
RIGHT
Right / Left
Front speakers 2
Subwoofer
Right front speaker(s)
(R)
Right surround
speaker (RS)
IMPORTANT:
After connecting the speakers, set the speaker setting
information properly:
• To obtain the best possible Surround/THX/DSP effect in Zone 1,
see "Basic Settings" on pages 35 to 44.
• To connect the speakers to the FRONT 2/ZONE 2 SPEAKERS
terminals, set the speaker usage correctly.
(See "w Setting the Zone 2/Speakers 2 Usage—ZONE 2/
SPEAKER 2" on page 43.)
CAUTION : SPEAKER IMPEDANCE
CENTER
SURROUND
SPEAKERS
LEFT
RIGHT
Right / Left
Surround speakers
* When using only one surround back speaker,
connect it to the LEFT terminals.
Front speakers and center speaker
• Place these speakers (position of the mid-range speaker units) at
the same height from the floor.
• Place these speakers aiming at the listener's ears.
Surround and surround back speakers
• Place these speakers at a position which is 1 meter higher than
the listener's ears.
• Point these speakers down aiming at the listener's ears.
L
30˚
90˚
LS
60˚
LSB
Note:
Ideal speaker layout requires that all speakers be placed at the
same distance from the listener. However, since in some places it
may be difficult to fulfil this requirement, this unit can adjust the
delay time so that the sounds through all the speakers reach the
listener with the same timing. (See page 40.)
8 16
SURROUND BACK
SPEAKERS
+
–
LEFT
RIGHT
Right / Left
Surround back
speakers*
C
R
Subwoofer
30˚
90˚
RS
60˚
RSB