Audible Signals; Use Of The Appliance - AEG FAVORIT 55010 VI Notice D'utilisation

Masquer les pouces Voir aussi pour FAVORIT 55010 VI:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Press the on/off button. The appliance is in setting mode when:
– All the programme indicator lights come on and the digital display shows three horizontal
bars.
Press the on/off button. The appliance is not in setting mode when:
– Only one programme indicator light comes on and the digital display shows one hori-
zontal bar.
– A washing programme is set. It is necessary to cancel the programme to go back to the
setting mode. Refer to the chapter 'Setting and starting a washing programme'.

Audible signals

You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the indicator lights of function buttons
A, B and C start to flash.
4. Press the function button C.
– Indicator lights for function buttons A and B go off.
– Indicator light for function button C starts to flash.
– The end-of-programme indicator light comes on.
The audible signals are activated.
5. Press the function button C again.
– The end-of-programme indicator light goes off.
The audible signals are deactivated.
6. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end-of-programme indicator light comes on.

Use of the appliance

Refer to the following instructions for each step of procedure:
1. Make a check if the water softener level is correct for the water hardness in your area.
If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dishwasher.
5. Set the correct washing programme for the type of load and soil.
6. Fill the detergent dispenser with the correct quantity of detergent.
7. Start the washing programme.
If you use combi detergent tablets ('3 in 1', '4 in 1', '5 in 1', etc.), refer to the chapter 'Multitab
function'.
Use of the appliance
33

Publicité

Table des Matières
loading

Table des Matières