Delay Start Button; Digital Display; Function Buttons; Audible Signals - AEG FAVORIT 45260 Notice D'utilisation

1)
1) The indicator light is off while a washing programme operates.

Delay start button

Use the delay start button to delay the start of the washing programme with an interval
between 1 and 19 hours. Refer to the chapter 'Setting and starting a washing programme'.

Digital display

The display shows:
• Adjusted level of the water softener.
• Programme duration.
• Remaining time to the end of the programme.
• End of a washing programme.
• Number of hours in delay start.
• Fault codes.
• Activation/deactivation of the audible signals.
NIGHT CYCLE button
Night Cycle is a silent washing programme that will not disturb you, even when you sleep.
You can set it:
• at night
• or in times with a more economical power rate.
During the Night Cycle the pump runs at a very low speed to reach a noise level reduction
of 25% compared to the declaration programme. As a consequence, it has a very long
running time.

Function buttons

Use the function buttons for these operations:
• To set the water softener. Refer to the chapter 'Setting the water softener'.
• To deactivate/activate the audible signals. Refer to the section 'Audible signals'.
• To cancel the washing programme in progress or a delay start in progress. Refer to the
chapter 'Setting and starting a washing programme'.

Audible signals

You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the indicator lights of function buttons
A, B and C start to flash.
Indicator lights
The indicator light comes on when it is necessary
to fill the rinse aid. Refer to the chapter 'Use of
rinse aid'.
27
Control panel