Setting And Starting The Programme With Delay Start; Interrupt A Washing Programme In Progress; End Of The Washing Programme - AEG Electrolux FAVORIT 88012 VI Notice D'utilisation

Setting and starting the programme with delay start

1. After having selected the washing programme, press the delay start button until the
number of hours for the delay start appear in the digital display. The start of the selected
washing programme can be delayed for between 1 and 19 hours.
2. Close the dishwasher door, the countdown starts automatically.
3. The countdown will decrease with steps of 1 hour.
4. The opening of the door will interrupt the countdown. Close the door; the countdown
will continue from the point at which it was interrupted.
5. Once the delay start has elapsed the programme will start automatically.
WARNING!
Interrupt or cancel a washing programme in progress ONLY if it's absolutely nec-
essary. Attention! Hot steam may escape when the door is opened. Open the door
carefully.
Cancelling a delay start or a washing programme in progress
• Simultaneously press and hold the two programme buttons positioned over the word
RESET, until 2 horizontal lines will appear in the digital display.
• Cancelling a delay start involves also the cancelling of the washing programme set. In
this case you have to set the washing programme again.
• If a new washing programme is to be selected, check that there is detergent in the
detergent dispenser.

Interrupt a washing programme in progress

• Open the appliance door, the programme will stop. Close the door, the programme will
start from the point at which it was interrupted.

End of the washing programme

• The dishwasher will automatically stop and an audible signal informs you of the end of
the washing programme.
1. Open the dishwasher door.
2. In the digital display is visible 0
3. The end of programme indicator light is illuminated.
4. Switch off the dishwasher by pressing the On/Off button.
It is recommended to switch off the appliance once the washing programme has ended. If
this is not done, automatically after about 3 minutes from the end of the programme, all
indicator lights will go off. The digital display shows 1 horizontal bar.
This will help to reduce the consumption of energy when you forget or for any reason
cannot switch the appliance off once the programme has ended.
Press any button (except On/Off) and the control panel will show the same situation (in-
dicator lights and digital display) as when the programme ended.
5. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in
this way they will be cooler and the drying will be improved.
Select and start a washing programme
55