Function Buttons - AEG Electrolux FAVORIT 88012 VI Notice D'utilisation

38
Control panel
6 Half load button
7 Indicator lights
8 On/Off button
9

Function buttons

Salt
Rinse aid
End of programme
1) The salt and rinse aid indicator lights are never illuminated while a washing programme is running even if filling
with salt and/or rinse aid is necessary.
The digital display indicates:
• the level of hardness to which the water softener is set,
• the number corresponding to the washing programme,
• the approximate remaining time of the running programme,
• activation/deactivation of the rinse aid dispenser ( ONLY with Multitab function active),
• the end of a washing programme (a zero will appear in the digital display),
• the countdown of the delay start,
• fault codes concerning malfunction of the dishwasher,
• activation/deactivation of the audible signals.
NIGHT CYCLE button
Night Cycle is a silent washing programme that will not disturb you, even when you sleep.
It can be set at night or in times with a more economical power rate.
During the Night Cycle the pump runs at a very low speed to reach a noise level reduction
of 25% compared to the declaration programme. As a consequence, it has a very long
running time.
Half load button
This option is useful and economical when baskets are not fully loaded. It reduces the
consumption of water and energy.
Remember to load both baskets.
When using this option we recommend to reduce the dose of detergent that is normally
used for a completed load.
This option is available only with some programmes (see "Washing programmes" chart).
Function buttons
The following functions can be set with the help of these buttons:
• setting of the water softener,
• cancel a washing programme or a delay start in progress,
Indicator lights
Illuminates when the special salt has run out.
Illuminates when the rinse aid has run out.
Illuminates when the washing programme has
ended.
1)
1)