Multi-Tab Function; Activation/Deactivation Of The Multi-Tab Function - AEG FAVORIT 44010 VIL Notice D'utilisation

16

Multi-tab function

Multi-tab function
This appliance is equipped with the "Multi-Tab function", that allows the use of the "Multi-
Tab" combi detergent tablets.
These products are detergents with a combined cleaning, rinsing and salt functions. They
can also contain other different agents depending on which kind of tablets you choose ("3
in 1", "4 in 1", "5 in 1" etc...).
Check whether these detergents are suitable for your water hardness. See the manufac-
turers instructions.
This function can be selected with all washing programmes. With the selection of this
function the inflow of rinse aid and salt from each respective supply container is auto-
matically deactivated and also the indicator lights for salt and rinse aid are deactivated.
Select the "Multi-Tab function " before the start of a washing programme.
Once this function is selected (indicator light illuminated) it will remain active also for the
following washing programmes.
With the use of the "Multi-Tab function", the cycle durations may change.
Once the programme is running, the "Multi-Tab function " can NO longer be changed. If
you want to exclude the "Multi-Tab function " you have to cancel the programme setting
and then deactivate the "Multi-Tab function ".
In this case you have to set a washing programme (and desired options) again.

Activation/deactivation of the Multi-Tab function

Press the Multi-tab button: the corresponding indicator light illuminates. This means that
the function is active.
To deactivate the function press the Multi-tab button again: the indicator light turns off.
If the drying results are not satisfactory we suggest that you:
1. Fill up the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• The activation/deactivation of the rinse aid dispenser can only be possible with the
"Multi-Tab function" active.
Activation/deactivation of the rinse aid dispenser
1. Press the On/Off button. The dishwasher must be in setting mode.
2. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start
flashing.
3. Press button B, the lights of buttons A and C turn off while the light of button B goes
on flashing. The digital display indicates the current setting:
deactivated.
4. To change the setting, press button B again, the digital display indicates the new setting:
= Rinse aid dispenser activated.
5. To memorise the operation, switch off the dishwasher by pressing the On/Off button.
= Rinse aid dispenser