Setting Electronically; Use Of Dishwasher Salt - AEG FAVORIT 44010 VIL Notice D'utilisation

8

Use of dishwasher salt

1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position 1
or 2 (see table).
4. Replace the lower basket.

Setting electronically

The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher must be in setting mode.
2. Press simultaneously and keep pressed buttons B and C, until the lights of buttons A,
B and C start flashing.
3. Press button A, the lights of buttons B and C turn off while the light of button A goes
on flashing. At the same time the End of programme indicator light starts flashing
along with a sequence of intermittent audible signals. The current level is indicated by
the number of flashes of the End of programme indicator light, (see chart) together
with a sequence of intermittent audible signals and a pause of few seconds.
Examples:
5 flashes / 5 intermittent audible signals, pause, 5 flashes / 5 intermittent audible signals,
pause = level 5
4. To change the level, press button A. Each time the button is pressed the level changes.
(For the selection of the new level see the chart).
Examples: if the current level is 5, by pressing button A once, level 6 is selected. if the
current level is 10, by pressing button A once, level 1 is selected.
5. To memorise the operation, switch off the dishwasher by pressing the On/Off button.
Use of dishwasher salt
WARNING!
Only use salt specifically designed for use in dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, especially table salt, will damage the water soft-
ener. Only fill with salt just before starting one of the complete washing programmes. This
will prevent any grains of salt or salty water, which may have been spilt, remaining on the
bottom of the machine for any period of time, which may cause corrosion.
To fill:
1. Open the door, remove the lower basket and unscrew the cap of the salt container by
turning it anticlockwise.
2. Pour 1 litre of water inside the container (this is necessary only before filling with
salt for the first time) .