Setting Manually; Setting Electronically - AEG FAVORIT 35020 I Notice D'utilisation

°dH
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4

Setting manually

The dishwasher is factory set at position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position 1
or 2 (see table).
4. Replace the lower basket.

Setting electronically

The dishwasher is factory set at level 5.
1. The dishwasher must be switched off.
Keep the START/RESET button pressed and turn the programme knob clockwise until
the programme marker corresponds with the first washing programme.
2. Release the START/RESET button , the On/Off and START/RESET indicator lights
start to flash indicating that you have activated the water softener setting function.
3. At the same time, the end of programme indicator light starts to flash.
The current level is indicated by the number of flashes of end of programme indicator
light and a pause of about 3 seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc... = level 5
6 flashes, pause, 6 flashes, pause, etc... = level 6
4. To change the level, press the START/RESET button . Each time the button is pressed
the level changes.
Water hardness
°TH mmol/l
91 - 125 9,1 - 12,5
76 - 90 7,6 - 8,9
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7
Adjusting the water hardness
manually
2
2
2
2
2
2
1
1
1
< 0,7 1
Set the water softener
setting
electronically
level 10
level 9
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
7
Use of salt
yes
yes
yes
yes
yes
yes
yes
yes
yes
no