32
Control panel
Delay start button
Use this button to delay the start of the washing programme with an interval of 3 hours.
Refer to 'Select and start a washing programme'.
Programme lights A and B
These lights have also an auxiliary function when you:
• Adjust the level of the water softener.
• Deactivate/activate the audible signals.
Setting mode
The appliance must be in setting mode for these operations:
• To select and start a washing programme.
• To adjust electronically the level of the water softener.
• To deactivate/activate the audible signals.
Press the on/off button. The appliance is in setting mode when:
• All the programme lights are off and the end-of-programme indicator light flashes.
Press the on/off button. The appliance is not in setting mode when:
• Only one programme light comes on.
– It is necessary to cancel the programme to go back to the setting mode. Refer to
'Select and start a washing programme'.
Audible signals
You can hear the audible signals when:
• The washing programme ends.
• The appliance has a malfunction.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme button until the programme light A flashes and the
programme light B comes on.
4. When the programme light A flashes and the programme light B comes on, press im-
mediately the programme button again.
The programme light A comes on and the programme light B starts to flash.
After some seconds the programme light A goes off and the end-of-programme indi-
cator light comes on. (The programme light B continues to flash).
– The audible signals are active.
5. Press the programme button again. The end-of-programme indicator light goes off.
– The audible signals are deactivated.
6. Switch of the appliance to confirm the operation.
Do these steps to activate again the audible signals:
1. Follow the procedure how to deactivate the audible signals from point 1 to point 4.