Manual Adjustment; Electronic Adjustment - AEG FAVORIT 34030VI Notice D'utilisation

34
Setting the water softener
German degrees
(°dH)
< 4
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener manually and electronically.

Manual adjustment

Turn the water hardness dial to the position 1 or
2 (refer to the table).

Electronic adjustment

1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme button until the programme light A starts to flash
and the programme light B comes on.
4. When the programme light B goes off and the end-of-programme indicator light
starts to flash, press the programme button again. (The programme light A continues
to flash).
At this point the electronic adjustment of the water softener is active.
– The end-of-programme indicator light shows sequences of flashes with a pause of
some seconds between each sequence. The number of flashes shows the set level.
– Example: 5 flashes / pause / 5 flashes = level 5.
5. Press the programme button to change the adjustment. Each time you press the pro-
gramme button the adjustment goes to the subsequent level.
6. Switch off the appliance to keep the operation.
If the water softener is set electronically to the level 1, the salt indicator light stays off.
Water hardness
French degrees
(TH°)
< 7
mmol/l Clarke de-
grees
< 0,7 < 5
Water hardness ad-
justment
manually elec-
troni-
cally
2) 2)
1 1