Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
34
Setting the water softener
Setting the water softener
The water softener removes minerals and salts from the water supply. Minerals and salts
can have bad effect on the operation of the appliance.
Water hardness is measured in equivalent scales:
• German degrees (dH°).
• French degrees (°TH).
• mmol/l (millimol per litre - international unit for the hardness of water).
• Clarke.
Adjust the water softener to the water hardness in your area. If necessary, contact your
local water authority.
°dH
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) No use of salt required.
You must set the water softener manually and electronically.
Manual adjustment
The appliance is set at the factory at position 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position 1
or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.
Electronic adjustment
The water softener is set at the factory at level 5.
Water hardness
°TH
mmol/l
91 - 125
9,1 - 12,5
76 - 90
7,6 - 9,0
65 - 75
6,5 - 7,5
51 - 64
5,1 - 6,4
40 - 50
4,0 - 5,0
33 - 39
3,3 - 3,9
26 - 32
2,6 - 3,2
19 - 25
1,9 - 2,5
7 - 18
0,7 - 1,8
< 7
< 0,7
Water hardness setting
Clarke
manually
64 - 88
2
53 - 63
2
46 - 52
2
36 - 45
2
28 - 35
2
23 - 27
2
18 - 22
1
13 - 17
1
5 - 12
1
< 5
1)
1
electronically
10
9
8
7
6
5
4
3
2
1)
1
Publicité
Chapitres
Table des Matières
