Use Of Dishwasher Salt - AEG FAVORIT 55010 VI Notice D'utilisation

1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the indicator lights for function buttons
A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator light for function button A continues to flash.
– The indicator lights for function buttons B and C go off.
– The end-of-programme indicator light starts to flash.
– You can hear an audible signal.
The setting function of the water softener is activated.
The end-of-programme indicator light flashes and an audible signal operates to show
the level of the water softener. The pause is approximately 3 seconds.
Example: 5 flashes / 5 intermittent audible signals - pause - 5 flashes / 5 intermittent
audible signals - pause - etc. = level 5
6. Press the function button A one time to increase the water softener level by one step.
7. Press the on/off button to save the operation.

Use of dishwasher salt

CAUTION!
Only use dishwashers salt. Types of salt that are not applicable for dishwashers cause dam-
age to the water softener.
CAUTION!
Grains of salt and salty water on the bottom of the appliance can cause corrosion. Fill the
appliance with salt before you start a washing programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the salt container.
2. Fill the salt container with 1 litre of water (only the first operation).
3. Use the funnel to fill the salt container
with salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
It is normal that water overflows from the salt
container when you fill it with salt.
When you set electronically the water soft-
ener to level 1, the salt indicator light does not
stay on.
Use of dishwasher salt
35