Water Connection; Inlet Hose; Drain Hose - AEG FAVORIT 45260 Notice D'utilisation

Water connection

Inlet hose

The appliance has safety features to prevent that the water in the appliance goes back into
the drinking water system.
Connected the appliance to a hot (max. 60°) or cold water supply.
If the hot water comes from alternative sources of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and aeolian), use a hot water supply to decrease
energy consumption.
It is important that a water tap or stopcock is near the dishwasher with easy access.
Connect the inlet hose to a water tap with an external thread of 3/4".
If the water inlet hose is too short, replace the water inlet hose with an applicable, longer
high-pressure hose. Do not connect an extension hose.
To suit the installation, it is possible to turn the end of the hose that is connected to the
dishwasher. Do these steps :
1. Loosen the retaining nut.
2. Turn the hose.
3. Tighten the retaining nut.
WARNING!
Make sure that the retaining nut and all other connections are tight before you move the
dishwasher into position.
WARNING!
Always use a new water inlet hose. Do not use connection hoses from an old appliance.

Drain hose

The appliance has water safety system to prevent water damage. If there is a malfunction,
the drain pump automatically starts to drain the remaining water out of the dishwasher.
WARNING!
Only if the dishwasher is connected to the mains socket, the water safety system operates
when the dishwasher is off.
If you connect the water drain hose to a trap spigot under the sink, remove the plastic
membrane (A). If you do not remove the membrane, remaining food can cause a blockage
in the drain hose spigot
Water connection
41