Spray Patterns - Titan SPEEFLO PowrTwin 4900 Plus Notice D'utilisation

Spray Patterns

Problem
A. Tails
B. Hour glass
C. Distorted
D. Pattern expanding and
contracting (surge)
E. Round pattern
Patents
These products are covered by one or more of the following U.S. patents:
5,947,381 5,749,528
Material Safety Data Sheets (MSDS) are available on Titan's website or by calling Customer Service.
© Titan Tool Inc. All rights reserved.
Troubleshooting
cause
1. Inadequate fluid delivery
1. Inadequate fluid delivery
1. Plugged or worn nozzle tip
1. Suction leak
2. Pulsating fluid delivery
1. Worn tip
2. Fluid too heavy for tip
5,660,332 5,425,506
Solution
1. Fluid not atomizing correctly:
Increase fluid pressure. Change to smaller tip orifice
size. Reduce fluid viscosity. Reduce hose length.
Clean gun and filter(s). Reduce number of guns
using pump.
1. Same as above.
1. Clean or replace nozzle tip.
1. Inspect for suction hose leak.
2. Change to a smaller tip orifice size. Install pulsation
dampener in system or drain existing one. Reduce
number of guns using pump. Remove restrictions in
system; clean tip screen if filter is used.
1. Replace tip.
2. Increase pressure. Thin material. Change nozzle tip.
15 English