Kärcher SB VC 1 Mode D'emploi page 28

Cleaning the flat fold filter using the automatic dedusting function
Step 1
 Turn on the appliance.
Step 2
 Switch the automatic filter dedusting off
using the switch.
1 Indicator lamp
2 Automatic filter dedusting switch
Step 3
 Seal off the car nozzle with your hand.
Note
Keep the car nozzle closed during automat-
ic filter dedusting.
1 Car vacuuming tool
Step 4
 Switch the automatic filter dedusting on
using the switch.
Step 5
 The flat fold filter is now automatically
cleaned by three pulsating air bursts.
 Repeat step 2 to step 4 .
Repeat the procedure 5 to 8 times (or
depending on the degree of soiling).
Then check the suction power.
28
Note
The indicator lamp must light up green after
the cleaning procedures.
Note
Cleaning the flat fold filter using the auto-
matic dedusting function removes the fine
dust clogging the pores of the flat fold filter.
Any existing fluff does not impair the suc-
tion power.
If necessary, carefully remove any existing
fluff using a brush.
A Flat fold filter before cleaning
B Flat fold filter after cleaning
ATTENTION
The flat fold filter is damaged if kinked,
beaten out or cleaned with compressed air.
– 9
EN