JVC EXAD KD-LHX601 Manuel D'instructions page 11

3
Press and hold ¢
until "Manual Search" starts flashing
on the display.
4
Tune in to a station you want while
"Manual Search" is flashing.
To tune in to stations of lower frequencies
• If you release your finger from the button,
the manual mode automatically turns off
after about 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for
FM and 9 kHz for AM—MW/LW) until you
release the button.
If the sound quality decreases and the
stereo effect is lost while listening to an
FM station
In some areas, adjacent stations may
interfere with each other. If this interference
occurs, this unit can automatically reduce this
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound
quality and to lose the stereo effect, rather
than to eliminate the interference noise, see
"To change the FM tuner selectivity—IF Filter"
on page 56.
or 4
To tune in to stations
of higher frequencies
To tune in to FM stations only with strong
signals—LO/DX (Local/Distance-extreme)
While searching FM stations (including SSM—
see page 12), this unit stops searching whenever
it detects signals (DX mode: The DX indicator is
lit—initial setting). If received signals are weak,
you may only hear noises.
By setting LO/DX to "Local," you can make this
unit detects only stations with sufficient signal
strength.
1
Press M (MODE) while listening to an FM
broadcast.
"Mode" appears on the display.
The next-step-operation buttons
start flashing.
See page 46 for this function.
2
Press number button 2, while "Mode" is still
on the display.
Each time you press the button, the "LO/DX"
setting alternates between "Local" and "DX".
After about
5 seconds
The display returns to the source indication
screen.
LO indicator appears
11