Programming Additional Functions - Reely 4WD RtR Notice D'emploi

b) Programming additional functions
By default, the speed controller is preprogrammed with the optimal settings.
When using LiPo rechargeable batteries to operate the vehicle, check whether low voltage protection is
enabled in the default setting of the speed controller (normally 3.0 V per cell). When low voltage detection
is disabled, LiPo rechargeable batteries are subject to a deep discharge that destroys them.
The setup button can be used to program the settings.
Proceed as follows:
• Switch on the remote control.
• Turn off the speed controller by pressing and holding
down the on/off button (A) for more than 0.5 seconds.
• Keep the setup button (B) pressed and turn on the
speed controller by briefly pressing the on/off button (A).
Keep holding down the setup button (B).
• The red LED (C) on the speed controller will flash eight
times and the motor will emit beeps (keep the setup but-
ton (B) pressed).
• The speed controller is then in programming mode. The red LED (C) and beeps emitted by the motor indicate which
programming function is currently selected (see the table on the next page and the descriptions below). Keep the
setup button (B) pressed.
Example: Red LED flashes twice briefly and 2 short beeps are emitted: Select rechargeable battery type LiPo/NiMH
• When the desired programming function you want to change is displayed (for example, select rechargeable battery
type LiPo/NiMH, red LED flashes twice briefly and the motor emits 2 short beeps), release the setup button (B).
• The red LED and the beeps now indicate the available settings.
Example: Red LED flashes once briefly and 1 short beep is emitted: LiPo rechargeable battery type
Red LED flashes twice briefly and 2 short beeps are emitted: NiMH rechargeable battery type
• To save the selection, turn off the speed controller by pressing and holding down the on/off button (A) for more than
0.5 seconds. If you then turn on the speed controller, it will be ready for operation with the new settings.
• Follow the above steps to change the other settings.
The greyed out values in the table on the next page a re the default settings after a reset (see chapter
10. c). The speed controller of your vehicle may have a different default setting upon delivery; then note the
flashing signals of the red LED and the respective beeps.
47