Programming The Speed Controller; Adjusting The Neutral And Full Throttle Setting - Reely 4WD RtR Notice D'emploi

10. Programming the speed controller

a) Adjusting the neutral and full throttle setting
If the vehicle does not stay stationary when the throttle/brake lever is in the neutral position, you can adjust the throttle
trim on the remote control. If the trim is insufficient (or if the trim is almost in the end position), you can reset the trim
accordingly.
Proceed as follows:
• Switch on the transmitter, leave the throttle/brake lever
in the neutral position. Set the trim for the drive function
to the neutral position.
• The "TH.REV" slide switch of the included transmitter
must be pushed upwards (in the direction of the "TH.
REV" inscription).
• Turn off the speed controller by pressing and holding
down the on/off button (A) for more than 0.5 seconds.
• Keep the setup button (B) pressed and turn on the speed controller by briefly pressing the on/off button (A).
• The red LED (C) on the speed controller will then flash and the motor will emit beeps. Release the setup button.
Beeps are generated by a brief activation of the motor.
• Release the throttle/brake lever on the remote control so that it is in the neutral position.
• If you press the setup button (B) briefly, the red LED on the speed controller will flash once briefly and you will then
hear a beep. The neutral position has been saved.
• Move the throttle/brake lever on the transmitter to the full speed throttle position, then pull it as far as it will go in the
direction of the handle and hold it there.
Caution!
If you do not move the throttle/brake lever on the transmitter or do not move it far enough during program-
ming, the vehicle may respond to even minute movements of the throttle/brake lever on the transmitter or
become uncontrollable upon completion of programming. In this case, reprogram it.
• If you press the setup button (B) briefly, the red LED on the speed controller will flash twice briefly and you will then
hear two beeps. The full forwards throttle position will be saved.
• Move the throttle/brake lever to full reverse throttle (push the lever away from the handle as far as it will go).
• If you press the setup button (B) briefly, the red LED on the speed controller will briefly flash three times and you
will hear three beeps. The full reverse throttle position will be saved.
• Release the throttle/brake lever to return it to the neutral position. Now wait at least 3 seconds, then the setting
mode is exited and the speed controller is ready for use with the new settings made (LED and sound signals are
emitted according to chapter 9. g)).
46