Chapter 3: Use Of Icare+ Device; Setup; Installing The Icare+ Device; Connection To The Air System - NSK iCare+ Mode D'emploi

CHAPTER 3: USE of iCare+ DEVICE

3.1. Setup

3.1.1. Installing the iCare+ device

3.1.2. Connection to the air system

Insert the air supply tube in the air filter: J, fixed on the Rear panel's device. Be sure that the air tube is attached
properly to the filter (see Figure 6). Connect the "T-shaped fast-on" connector to the surgery compressor's air supply
and after that connect your dental unit.
iCare+ User Manual V11.4 • 09/2017
CAUTION: The use of controls, settings or the implementation of procedures other
than those specified below may expose users and patients to danger
You should install the iCare+ device as requested below:

The device should be positioned on a flat, solid and level surface. Do not
level itself but the surface it is placed on. The maximum weight of the device
with the maximum weight, fully loaded, in conditions of use is 16 kg

The device should not be placed near a sink or any source that may splashed
it

The device should be placed in a room properly ventilated

The device should be kept away from any source of heat
Figure 6: Connection of the tube in the
pneumatic system of iCare+ device
J
p. 12