Residual Risks - Black & Decker KS900E Mode D'emploi

Additional features (Fig. A)
Additional features may be applicable
depending upon the product purchased. The
additional features applicable to the catalogue
number purchased are shown in fig. A.
Assembly
Warning! Before attempting any of the following
operations, make sure that the tool is switched
off and unplugged and that the saw blade has
stopped. Used saw blades may be hot.
Fitting and removing the saw
blade (Fig. B and C)
Warning! Before attempting any of the following
operations, make sure that the tool is switched
off and unplugged and that the saw blade has
stopped. Used saw blades may be hot.
Fitting the saw blade (Fig. B)
•
Hold the saw blade (10) as shown, with the
teeth facing forward.
•
Push and hold the blade clamp (11) down.
•
Insert the shank of the saw blade into the
blade holder (12) as far as it will go.
•
Release the blade clamp (11).
Saw blade storage (Fig. C)
Saw blades (10) can be stored in the storage
compartment (4) located on the side of the tool.
•
Open the cover of the saw blade storage
compartment (4) by holding the tab on the
top of the cover and pulling it outward.
•
The blades are retained in the compartment
by a magnetic strip. To remove a blade,
press down on one end of the blade to raise
the other end, and remove.
•
Close the cover of the saw blade storage
compartment (4) and make sure that it is
latched closed.
Warning! Close the storage compartment door
securely before operating the saw.
Connecting a vacuum cleaner to
the tool (fig. D)
An adaptor (13) is required to connect a vacuum
cleaner or dust extractor to the tool.
•
Push the adaptor (13) into the dust extraction
outlet (6).
•
Connect the vacuum cleaner hose (14) to the
adaptor (13).
Cut line blower (Fig. E)
•
To aid visibility when cutting, your jigsaw is
equipped with a cut line blower (15) which will
keep the work area clear of dust as you saw.

Residual risks

Additional residual risks may arise when using
the tool which may not be included in the
enclosed safety warnings. These risks can arise
from misuse, prolonged use etc.
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These include:
•
Injuries caused by touching any
rotating/moving parts.
•
Injuries caused when changing any parts,
blades or accessories.
•
Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
make sure you take regular breaks.
ENGLISH
9