Electrical Safety - Black & Decker KS900E Mode D'emploi

ENGLISH

Electrical safety

This tool is double insulated; therefore
no earth wire is required. Always check
that the power supply corresponds to the
voltage on the rating plate.
•
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre in
order to avoid a hazard.
Additional safety instructions
for non-rechargeable batteries
•
Never attempt to open for any reason.
•
Do not store in locations where the
temperature may exceed 40°C.
•
When disposing of batteries, follow the
instructions given in the section "Protecting
the environment".
•
Do not incinerate the batteries.
•
Under extreme conditions, battery leakage
may occur.
•
When you notice liquid on the batteries,
proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
Additional safety instructions
for lasers
Read all of this manual carefully.
This product is not to be used by
children under 16.
Laser radiation.
Do not look into the laser beam.
Do not use optical tools to view
the laser beam.
8
•
This laser complies with class 2 according to
EN 60825-1:2007. Do not replace a laser
diode with a different type. If the laser is
damaged, have the laser repaired by an
authorised repair agent.
•
Do not use the laser for any purpose other
than projecting laser lines.
•
An exposure of the eye to the beam of a class
2 laser is considered safe for a maximum of
0.25 seconds. Eyelid reflexes will normally
provide adequate protection. At distances
greater than 1m, the laser complies with class
1 and is therefore considered completely
safe.
•
Never look into the laser beam directly and
intentionally.
•
Do not use optical tools to view the laser
beam.
•
Do not set up the tool where the laser beam
can cross any person at head height.
•
Do not let children come near the laser.
Features
1. Variable speed control knob
2. On/off switch
3. Lock-on button
4. Blade storage compartment cover
5. Shoe plate locking lever
6. Dust extraction outlet
7. Shoe plate
8. Saw blade support roller
9. Pendulum stroke selector